- About Us
- Technical Info
5" Diameter Filter for Fine Dust
Dust Collector Configuration - Select the Air Volume required or the Fan (hp) Horse-Power required
CHOOSE A MODEL LISTED BELOW TO CONTINUE CONFIGURING YOUR DUST COLLECTOR SYSTEM.
REFER TO THE BROCHURE IF NEEDED HERE:
Note: If uncertain of air volume requirements a good starting point is to itemize the machines to ventilate. Note their port sizes in diameter (inches). Then look up these diameters on our charts here http://www.kraemertool.com/CFM.htm or look up the machine type on same chart and note the recommended CFM per machine or calculate the port areas. ***IMPORTANT STEP***
Multiply each area- Eg. 6"dia. port (Area = 0.1964) x 4500 ft/min = 883.8 CFM required.
Do this for each port until you have the total airflow required. Then select your model that is closely matched to that airflow volume.
Eg. Total airflow = 4600 CFM Therefore use: Model B15/15 Type B Dust Collector
Note: 4500 ft/min is the recommended air speed of dust in the ducting by NFPA